4. Place the battery pack, or the radio with the battery attached, into the charging
slot on the charger.
5. Check that the Red LED on the charger is illuminated.
6. The fast charging process will be initiated. When the battery pack is fully
charged, the Green LED on the charger will be illuminated see Table 3
Charge State
LED States
Red LED
Green LED
Battery absent
Off
Off
Fast Charge
On
Off
Charge Complete
Off
On
Charge suspended (High or Low Temp
1 Hz Flashing
Off
Table 3: Charge Indications.
2.1.3. Fitting the Battery
Insert the battery into the bottom of the radio. (See arrow 1 in Figure 1 below).
Press down slightly on the battery release clip located at the top of the battery until a
click is heard. see Figure 1.
Figure 1: Fitting the Battery.
To remove the battery, turn the radio off. Slide the battery release clip downwards to
release the battery.
2.1.4. Fitting the Antenna
With the radio turned off, locate the antenna in its threaded socket and turn clockwise
to tighten.
Doc Number:
TNM-U-E-0114 ISSUE 1.4
Page
31
