Installation Instructions Document No. 466-1574
11
Use the following three tables to help you further plan module installation.
Table 4 Unit Number Assignments*
Unit Number
(1 through 16)
Result
1-8
Used for sensor-activated, time-activated, and entry/exit delay lights.
Sensor-activated lights are enabled and disabled pressing the LIGHTS Sensor Activated
button on the Control Panel.
Time-activated lights are enabled and disabled by pressing the LIGHTS Time Activated
button on the Control Panel.
If using the universal module to operate a garage door, be sure to assign a unique unit number.
The STAR button on the KeyChain Touchpad activates the universal module to open the
garage door or to turn on special lights if programmed.
9-16
Used for lamp modules and controlled by an all on or all off command.
9
Used for remote siren to hear arming level beeps, status beeps and trouble beeps.
If set to any other number the user will hear only alarm sounds.
10
Lamps will flash to arming level.
Table 5 House Code Assignments*
House Codes
Results
A through O
Set all modules to the same house code
except the remote sirens
Next Higher House Code
Remote Siren needs to be the next higher
alphabetical letter
Table 6 Home Control Planning Table*
Module
Activated by
Time Activated
Unit #
Type
Location
Sensor
Entry/Exit
Start Time
Stop Time
Example
Lamp
Hall lamp
Motion
Yes
8 p.m.
10:30 p.m.
1
2
3
4
5
6
7
8
* = Not Available with Basic Model
