Installation Instructions Document No. 466-1574
.
12
Planning System Access Codes
Use the following to plan system Access Codes. Fill
out Table 7 on page 10 to use when programming
these codes.
Utility Access Code 1
This access code is used during installation. The de-
fault utility access code is 4321. This code can be used
for all programming.
Utility Access Code 2
The default access code is 4321. This access code is
used for all programming except changing utility ac-
cess code 1 and changing options 4, 5, 6, 8, 9, 12, and
13.
Master Access Code
The default Master Access Code is 1234. This user
code is used to: disarm the Control Panel, subdisarm
the Control Panel, program options 1 through 3, 36,
37, 41 - 43, program light control, set the system
clock, program the master code, program access
codes 1-5, program the panic code, and perform a sen-
sor or phone test.
Note: If the installer deletes the master access code, the
owner may enter program mode by pressing cancel.
Access Codes (1 - 5)
The Control Panel can have up to 5 secondary user ac-
cess codes. These could be used by children, a baby
sitter, or a service person. These codes cannot be used
for programming.
Panic Code
The Panic Code is able to disarm or subdisarm the
panel and send a silent alarm to the Central Station.
There will be no indication of an alarm at the panel.
Planning System Options
Use the following to plan system Options. See Table
18 on page 19 for a complete listing of all system op-
tions and their characteristics. Fill out the last column
of this table to use when programming.
Option 01: Panel Piezo Beeps
Add turns on panel beeps that sound when an access
code is entered or when the arming level is changed.
The arming buttons will cause beeps according to the
arming level. See Table 8 on page 11 for a detailed ex-
planation of panel piezo beeps.
Delete turns off panel piezo beeps.
Option 02: Panel Voice
Add enables the panel’s voice.
Delete disables the panel’s voice.
Note that the panel voice is always on for status mes-
sages, open sensor responses, and when in program
mode.
Table 7 System Access Codes
Type
Default
Installer
Settings
Utility Access Code 1
4321
Utility Access Code 2
4321
Master Access Code
1234
Access Code 1
None
Access Code 2
None
Access Code 3
None
Access Code 4
None
Access Code 5
None
Panic Code
None
