www.simondstore.com
Page
7
of
7
Operating Instruction
1.
Open the wing nut slightly at the top of PART B.
2.
Open the outlet valve of propane gas cylinder.
3.
Open the gas inlet valve on PART C to enable gas flow in the burner.
4.
Light up the Forge by using Lighter at the opening of the burner inside the Forge body.
5.
Now adjust the gas flow using inlet valve and air flow using the wing nut to get the complete combustion of gas
and desired flame intensity.
6.
Place the iron article to be forged inside the forge and under the flame using tongs.
7.
Remove the article one it is red hot and ready for shaping, safely using tongs.
8.
Close the gas our let valve of the propane cylinder and wait until fire in the forge stops.
9.
Remove the propane cylinder connections to the forge and place it away from forge.
10.
Allow Forge to cool down to normal temperature before transferring it to other place it required.
