7
5. a
ssembly
I
nstructIons
5.1 Surface Preparation
Before beginning any cleaning task, it is important to inspect the
area for objects that could create a hazard. Remove any objects
from the work area that could be tripped over, such as toys or
outdoor furniture. Ensure that all doors and windows are closed
tightly.
5.2 Water Supply (Cold Water Only)
Only draw water through the unit. The device must be used with
cold water supply only. The water hose must be at least 1/2”
(13 mm) in diameter. The water flow rate must not fall below
2 GPM (9.1 LPM). The flow rate can be determined by running
water for one minute into an empty container. The water supply
temperature must not exceed 40°C (104°F).
5.3 Safety Advice
CAUTION
•
Never use the pressure washer to draw in water
contaminated with solvents (e.g. paint thinners,
gasoline, oil, etc.).
•
Dirt in the water inlet will damage the unit. To avoid this
risk, we recommend checking the water filter (located
inside the water inlet. To clean it out, refer to the Cleaning
and Maintenance section).
•
Always prevent debris from being drawn into the unit by
using a clean water source and an additional accessory
water filter, if required.
•
To prolong the life of the unit, let it rest for 5 minutes
after every 30 minutes of use.
•
Check to make sure you have all the parts.
5.4 Assembly Steps
A
Insert upper handle frame into the lower handle and align the
holes. Tighten the knobs by hand.
S
Assemble the bottle holder.
Assembly Instructions
