Digital Half Cylinder
Page 11
5. Fix the electronics module to the flange with the Allen screws that are parallel
to the battery (same Allen key). Make sure that the cable is not pinched.
6. Connect the cable to the electronics socket and lay it so that it is flat on the
electronics covering and not in the way when screwing on the knob (danger of
pinching).
7. Use an authorised transponder to couple the half cylinder and tightly screw
the knob in until the stop. While doing this, you must firmly hold the catch with
your hand if the half cylinder is not installed. If the half cylinder is installed, the
catch is held by the stop within the lock.
8. Firmly hold the knob and use the special tool for half cylinders to firmly screw
the locknut onto the knob.
6.6
Perform Function Test
1. Operate an authorised transponder and turn the knob in the lock and open di-
rections when the door is open. The knob must turn easily.
2. Close the door and repeat the process. If the locking cylinder is stiff, you must
align the door or correct the edge plate.
