Simple Audio Roomplayer I, User Manual

11

Connect a Simple Audio HomePlug (sold separately) or any 

compatible PowerLine AV 200 module to your router using 

the Ethernet cable provided. Plug your HomePlug into a 

mains socket and switch on. 

Now pair your HomePlug 

with your Roomplayer by following steps 1-6 below.

Always apply power to your HomePlug before your 

Roomplayer.

1

.

  Check that you have completed 

Option B

 above and that your 

HomePlug is switched on.

2

.

 Go to your Roomplayer, attach the 

mains lead and apply power. Now press

and hold the pairing button on the side 

of your Roomplayer for approximately 

10 seconds until the green LED on the 

front flashes. When you release the 

button the LED will go out.

3

.

 Go to your HomePlug, now 

press and hold the pairing button 

for approximately 10 seconds. 

Release the button when the 

pairing LED flashes. Your 

Roomplayer and HomePlug are 

now ready to link to each other.

5

.

 On your Roomplayer, press the 

pairing button for 2 seconds and 

release. The green LED on the front of 

your Roomplayer will flash for up to 2 

minutes, during this time it will pulse 

twice and go out.

6. The pairing process is complete. 

Pairing LED

Pairing button

Set up your first Roomplayer

Pairing button

Not using a Simple Audio HomePlug?

Refer to the pairing instructions supplied with your unit. 

Check 

www.homeplug.org

 for a list of all compatible 

modules

.

Do you already use a HomePlug?

If you are already using a HomePlug, you only need to 

follow steps 4 and 5 below.

6

Pairing button

Pairing LED

Pairing button

4. On your HomePlug, press the 

pairing button for 2 seconds and 

release. You must complete steps 

4 and 5 within 2 minutes, if not 

switch everything off and start 

the pairing process again.

Option B

Connect using a HomePlug.