Simple e SCOOTER 1, Manual

BATTERY INSTRUCTIONS 

BEFORE OPERATING FOR THE FIRST TIME, CHARGE THE BATTERY FOR 4 HOURS 

OR UNTIL FULLY CHARGED BUT UNDER NO CIRCUMSTANCES IN EXCESS OF 18 

HOURS. Be sure to charge the E-SCOOTER after each use. Keeping the battery 

properly charged will help extend the battery life. Do not use the E-SCOOTER while 

the power indicator on the instrument panel shows low energy. lf the E-SCOOTER is 

over-used the battery's life will be reduced. The E-SCOOTER uses a 48-72V (volt) 

battery pack. To charge the battery, connect the 3-pin plug into the charging 

receptacle located directly below the front seat. The Battery must be charged while 

installing the E-SCOOTER. lf you notice anything unusual about the battery such as a 

cracked or leaking battery case, a battery that gets hot while being used or charged, 

a battery case that appears "puffy'' or "bloated" etc, or there are any other problems 

with the battery, please contact us or your local workshop. The battery is sealed and 

is NOT user serviceable. Do not attempt to repair, remove, adjust or in any way alter 

any internal or electrical components, controls or wiring without first speaking with a 

customer service representative.

The main battery weighs approximately 9 kg. There is no need to remove it from the 

E-SCOOTER unless you are replacing it. Use caution on removal. To replace the main 

battery pack, lift the seat and unlock the lock located on the right side of the 

E-SCOOTER using the ignition key. Proceed to pull the battery out utilizing the handle. 

Disconnect the battery cable. The E-SCOOTER is equipped with a 48-72V battery 

charger that will interrupt the charging process once the battery has received a 

sufficient charge. We hereby strongly suggests that the charger is not used in excess 

of 18 hours to prevent any unnecessary wear off on the battery or charger itself. 

Charging for periods greater than 18hours may reduce the overall life expectancy and 

Efficiency of these items. 

1. 

!WARNING

 DO NOT CHARGE OR STORE THE MOTORING CLOSER THAN 20 FEET 

FROM ANY FLAME (E.G. FURNACE, FIREPLACE, WATER HEATER, SPACE HEATER) 

2. Be sure to only use 110V AC charger for NA and 220V AC charger for Europe. 

3. PLUG the POWER INPUT CORD into the E-SCOOTER charging receptacle located 

below the front of the seat or directly on top of the battery. See picture above. 

4. Plug the 48-72V battery charger into a 110V or 220V AC power source. 

5. The CHARGER INDICATOR LIGHT will illuminate confirming that power is 

connected to the charger. lf the light does not come on check all connections. lf it still 

does not come on after checking all connections, fuses and that your AC plug is 

working, unplug the charger and call your local dealer. 

!CAUTION DO NOT DROP THE BATTERY 

!CAUTION TO AVOID DAMAGE TO THE BATTERY WHEN CHARGING, USE 

ONLY THE CHARGER PROVIDED WITH YOUR E-SCOOTER

9