Simple e SCOOTER 1, Manual

! CAUTION

 IF YOU USE A SCREWDRIVER OR ANY TOOL OTHER THAN A TIRE 

LEVER, YOU ARE LIKELY TO PUNCTURE THE TUBE.  

6. 

Check to make sure that the tire is evenly seated around both sides of the rim and 

that the tube is inside the tire beads. Push the valve stem into the tire to make sure 

that its base is seated within the tire's beads. Inflate the tube slowly to the 

recommended pressure on the tire sidewall, all the while checking to make sure that 

the tire beads stay seated in the rim. 

! CAUTION

 BEFORE OPERATING YOUR E-SCOOTER, MAKE SURE THAT THE 

THROTTLE IS NOT ROTATED TO THE "ON" POSITION!!! MAKE ALSO SURE THAT YOUR 

THROTTLE IS NOT "STICKY" AND ROTATES FREELY BACK TO THE INITIAL POSITION 

SEE PICTURE FOR CORRECT PLACEMENT OF LEVER BEFORE USAGE!!!

OPERATING INSTRUCTIONS 

KEY AND THROTTLE OPERATION

ON/OFF/LOCK Switch: (ignition) 

1.

 E-SCOOTER is ON. Turn it ON only when you are ready 

to go. Turn it OFF when you are not riding and remove 

key. 

2.

 E-SCOOTER is OFF. Turn it OFF when not in use to 

preserve the battery. 

3.

 Push the key in on this position to lock the handlebar 

and turn the handlebar to the left. 

4. 

Handlebar is locked. The key can be removed. 

OPERATING INSTRUCTIONS 

The E-SCOOTER  driving system consist of four main components:

Battery

Throttle 

Motor

Controller 

5. 

Reinstall the tire and tube. Slip one tire bead over the rim. Insert the tube valve , 

through its hold in the rim. Feed the tube carefully into the cavity of the tire. Insert the 

tube just enough to give it some shape. Starting at the valve stem and working 

around both sides of the rim to the side opposite the valve stem, use your thumbs to 

push and seat the other bead at the tire inside the rim. Be careful not to pinch the 

tube between the tire bead and the wheel rim. lf you have trouble getting the last two 

inches of bead over the edge with thumb pressure, use a tire lacer and be careful not 

to pinch the tube.  

1 4

1.

2.

3.

4.