6
Figure 2-2.
The Line Access Cable
• The Line Access Cable (see Figure 2-2). This cable contains a
connector for the card, a standard jack for a phone line,
and a jack for a handset. The connector and the jacks are
keyed and will install in only the proper orientation.
The connector for the card latches to the card to ensure
continuous connection during use. To remove the cable
from the card, press on the latch-release buttons on both
sides of the connector.
The standard jack for the phone line is the wider jack
connection with only two wires.
The jack for the optional handset is the narrower jack
connection with four wires. The handset is for use with the
modem’s voice capabilities.
NOTE:
There is no industry standard for the signal
polarity of handsets; therefore, the handset
jack does not work with all handsets.
Connector for a Card
Latch Release
Buttons
To phone line
To Handset
0109
Summary of Contents for STI-FAX/28.8
