© 2011-2016 Tyco Fire Protection Products. Specifications and other information shown were current as of publication and are subject to change without notice.
TYCO, SIMPLEX, and the product names listed in this material are marks and/or registered marks. Unauthorized use is strictly prohibited.
579-977
Rev. C
Introduction
The 4606-9102 Liquid Crystal Display (LCD) Annunciator for the 4010ES provides remote
annunciation of the Fire Alarm Control Unit (FACU) status, see Figure 1. Visual status is
provided using an LCD and LEDs. Audible annunciation is provided using a piezo sounder. Use
the keyswitch to lock or enable the annunciator switch.
Figure 1. 4606-9102 LCD Annunciator
In this
publication
FIRE
ALARM
PRIORITY 2
ALARM
SYSTEM
SUPERVISORY
SYSTEM
TROUBLE
POWER
ON
ALARM
SILENCED
ALARM
ACK
ALARM
ACK
SUPV
ACK
TBL
ACK
ALARM
SILENCE
SYSTEM
RESET
DISPLAY
TIME
Topic
Page
Installing the 4606-9102 LCD Annunciator
Cautions
and warnings
READ AND SAVE THESE INSTRUCTIONS
-
Follow the instructions in this installation manual. These instructions
must be followed to avoid damage to this product and associated equipment. Product operation and reliability depend
upon proper installation.
DO NOT INSTALL ANY SIMPLEX® PRODUCT THAT APPEARS DAMAGED
-
Upon unpacking your
Simplex product, inspect the contents of the carton for shipping damage. If damage is apparent, immediately file a claim
with the carrier and notify an authorized Simplex product supplier.
ELECTRICAL HAZARD
-
Disconnect electrical field power when making any internal adjustments or repairs. All
repairs should be performed by a representative or authorized agent of your local Simplex product supplier.
STATIC HAZARD
-
Static electricity can damage components. Handle as follows:
• Ground yourself before opening or installing components.
• Prior to installation, keep components wrapped in anti-static material at all times.
EYE SAFETY HAZARD
-
Under certain fiber optic application conditions, the optical output of this device may exceed
eye safety limits. Do not use magnification (such as a microscope or other focusing equipment) when viewing the output
of this device.
SULFURIC ACID WARNING
-
Battery contains sulfuric acid, which can cause severe burns to the skin and eyes and
can destroy fabric. Replace any leaking or damaged battery while wearing appropriate protective gear. If you come in
contact with sulfuric acid, immediately flush skin or eyes with water for 15 minutes and seek immediate medical attention.
4606-9102 for 4010ES LCD
Annunciator installation instructions
