Instruction Manual
www.tksimplex.com
Hydraulic Chain Cutter – CCD1125
www.tksimplex.com
3
•
Perform maintenance operations with all pressure relieved (0 psi/bar).
•
Do not exceed equipment ratings. Use gauges or appropriate indicator devices to be aware of the working pressure.
•
After operation, clean the tool and store it in a clean, dry and secure location.
•
When using a powered pump, make sure that the valve is set to the neutral position before connecting the tool.
•
Ensure that the pump reservoir is full. Always check oil level with cutter blade fully retracted.
•
Ensure that heavy or sharp objects are positioned away from the hoses.
2. TECHNICAL DATA
GENERAL SPECIFICATIONS
Specification
CCD1125
Imperial
Metric
Push capacity
(@ 10150 psi or 700 bar)
38.8 Ton
345 kN
Length*
16.2 in
412 mm
Height*
7.2 in
183 mm
Width*
4.4 in
113 mm
Maximum Jaw Opening*
1.3
33
Weight
35.2 lb
16 kg
*
Due to rounding, the dimensions listed in this chart may be slightly different than the
dimensions shown in the diagrams in Section 6.
CUTTING CAPACITIES
Bar
Diameter*
Tensile Strength
in.
mm
ksi
MPa
1.18
30
102
700
0.98
25
145
1000
0.79
19
203
1400
0.67
17
232
1600
*Maximum diameter bar that can be cut at the different tensile strengths.
Chain
Diameter*
Grades
in.
mm
1.18
30
28-43
0.79
20
60-80
*Maximum diameter chain that can be cut at the different chain grades.
Manufacturer’s rating is the maximum allowable limit. Good practice encourages using the tool below
the manufacturer’s rating.
Keep the tool away from flames and heat, such as during welding.
Summary of Contents for CCD1125
Page 8: ......
