Instruction Manual
www.tksimplex.com
Hydraulic Chain Cutter - CCP0075
www.tksimplex.com
3
•
Before performing any maintenance procedures, press the release button to relieve pressure and return the blade to the fully
retracted position.
•
Do not exceed equipment ratings.
•
After operation, clean the tool and store it in a clean, dry and secure location.
2. TECHNICAL DATA
GENERAL SPECIFICATIONS
Specification
Model CCP0075
Imperial
Metric
Push capacity
(@ 10150 psi or 700 bar)
15.2 Ton
135 kN
Length*
19.3 in
489 mm
Height*
6.4 in
162 mm
Width*
3.0 in
76 mm
Maximum Jaw Opening*
0.8 in
20 mm
Weight
12.8 lb
5.8 Kg
*
Due to rounding, the dimensions listed in this chart may be slightly different than the
dimensions shown in the diagrams in Section 6.
CUTTING CAPACITIES
Bar
Diameter*
Tensile Strength
in
mm
ksi
MPa
0.75
19
102
700
0.59
15
145
1000
0.51
13
203
1400
0.43
11
232
1600
* Maximum diameter bar that can be cut at the different tensile strengths.
Chain
Diameter*
Grades
in
mm
0.75
19
28-43
0.55
14
60-80
* Maximum diameter chain that can be cut at the different chain grades.
Manufacturer’s rating is the maximum allowable limit. Good practice encourages using the tool below
the manufacturer’s rating.
Keep the tool away from flames and heat, such as during welding.
