Instruction Manual
www.tksimplex.com
Hydraulic Chain Cutter - CCP0075
www.tksimplex.com
4
3. OPERATION
1.
Using the stationary handle, hold the tool in the upright position (cutting head facing up).
2.
Move the blade forward by operating the integrated pump handle. Continue pumping until the blade reaches the end of its
stroke.
3.
Press the release button and check that the blade returns to its initial position.
4.
Insert the chain in the gap between the fixed and movable blades (max. 0.75 inch or 19 mm).
5.
Operate the integrated pump handle to advance the blade. Continue until the chain is fully cut.
6.
After cutting is completed, press the release button to move the blade back.
7.
Remove any traces of chain material before making another cut.
4. MAINTENANCE
REPLACEMENT OF BLADES
Note:
Refer to Section 6 of this manual for parts list and item numbers. To help prevent damage to the tool, always perform
blade replacement procedures in a clean and dry work area.
A.
FIXED BLADE:
1.
Loosen and remove the stud (16).
2.
Push the old blade (15) out using a nail inserted through the hole in the cutting head. Remove the old blade.
3.
Apply Loctite 242 to the threads of the stud (16).
4.
Insert a new blade (15). Reinstall and tighten the stud (16) to secure the blade.
B.
MOVABLE BLADE:
1.
Loosen and remove the studs (16), on both sides of the piston (24).
2.
Loosen the stud (28).
3.
Firmly grasp the cutting head. Unscrew the cutter body (11) from the cutting head (13).
4.
Loosen and remove the screw (17). Remove the old blade (14).
5.
Mount a new blade (14).
6.
Apply Loctite 242 thread sealant to the threads of the screw (17).Then, reinstall and tighten the screw (17) to secure the
blade.
7.
Thread the cutter body (11) fully into the cutting head (13). Tighten the stud (28).
8.
Apply Loctite 242 thread sealant to the threads of the studs (16). Then, reinstall the studs on both sides of the piston (24).
9.
Adjust the clearance between the piston (24) and the studs (16).
Note:
The studs (16) act as a piston guide. Turn each stud in or out as needed to adjust the clearance. There must be
sufficient clearance to allow the piston (24) to slide freely, but with a minimal amount of lateral movement. Clearance
should be even on both sides of the piston.
5. ADDITIONAL INFORMATION
All information, illustrations and specifications in this operation manual are based on the latest information available at the time of
publication. The right is reserved to make changes at any time without notice.
Equipment operators and installers shall be responsible for ensuring that a safe working environment and safe systems of work are
in place before operating the equipment.
Simplex declares that this product has been tested and conforms to applicable standards and complies with all CE requirements.
