Instruction Manual
www.tksimplex.com
Hydraulic Cable Cutter – HCCP3000
www.tksimplex.com
3
•
Before performing inspection or maintenance procedures, press the release button to relieve pressure and return the blade
to the fully retracted position (Note: it is permissible to advance the blade to allow access to the blade retaining screw
during blade replacement procedures).
•
Do not exceed equipment ratings.
•
After operation, clean the tool and store it in a clean, dry and secure location.
•
When working with wire rope, fraying may occur during the cutting operation. To help prevent this, bind the wire rope on
both sides of the cutting blade with tape or wire.
2.
TECHNICAL DATA
MODEL
HCCP3000
TOOL SPECIFICATIONS
Imperial
Metric
Capacity
7.9 Ton
70 kN
Pressure
10,150 psi
700 bar
Weight
14.5 lb
6.6 kg
Length
✝
25.6 in
650 mm
Width
✝
3.1 in
79 mm
Height
✝
7.8 in
198 mm
Max Jaw Opening
✝
3.0 in
77 mm
CUTTING CAPACITIES*
Wire Rope
Steel
Not recommended
Aluminum
1.57 in
40 in
Cable
Telephone
2.95 in
75 mm
Lead
2.95 in
75 mm
Underground
2.95 in
75 mm
✝
Due to rounding, dimensions listed in this chart may be slightly different than the
dimensions shown on the diagrams in Section 6.
*Maximum Diameter material that can be cut.
3.
OPERATION
1.
Using the stationary handle, hold the tool in the upright position (cutting head facing up).
2.
Move the blade forward by pumping the integrated pump handle. Continue pumping until the blade reaches the end of its
stroke.
3.
Press the release button and check that the blade returns to its initial position.
4.
Remove the retaining pin (attached to chain) securing the cutting head. Open the cutting head.
5.
Place the material to be cut inside the cutting head. Then, close the cutting head and secure it with the retaining pin. Make
sure the retaining pin is fully installed.
6.
Pump the integrated pump handle to advance the blade. Continue until the material is fully cut.
7.
After cutting is completed, press the release button to move the blade back. Open the cutting head and remove all traces of
material before making another cut.
Summary of Contents for HCCP3000
Page 8: ......
