OPERATION
17
en
Driving the Tractor
1. Sit in the seat and adjust the seat so that you can
comfortably reach all the controls and see the
dashboard display.
2. Engage the parking brake.
3. Make sure the PTO switch is disengaged.
4. Start the engine (see
Starting the Engine
).
5. Disengage the parking brake and release the
brake pedal.
6. Depress the forward ground speed control pedal to
travel forward. Release the pedal to stop. Note that the
further down the pedal is depressed the faster the tractor
will travel.
7. Stop the tractor by releasing the ground speed control
pedals, setting the parking brake, and stopping the
engine (see
Stopping the Tractor and Engine
).
Mowing
1. Set the mower cutting height to the desired level and set
the gauge wheels to the appropriate position.
2. Engage the parking brake. Make sure the PTO switch
is disengaged.
3. Start the engine (see
Starting the Engine
).
4.
Move the throttle control to the FAST position.
5. Engage the PTO (Mower Deck).
6. Begin mowing.
7. When finished, shut off the PTO and raise the mower
using the attachment lift control lever.
8. Stop the engine (see
Stopping the Tractor and
Engine
).
WARNING
The engine will shut off if the reverse ground speed
pedal is depressed while the PTO is on and the
RMO has not been activated. The operator should
always turn the PTO off prior to driving across
on roads, paths or any area that maybe used by
other vehicles. Sudden loss of drive could create a
hazard.
WARNING
Engines give off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause
nausea, fainting or death.
• Start and run engine outdoors.
• Do not start or run engine in enclosed area, even if
doors or windows are open.
Starting the Engine
WARNING
Fuel and its vapors are extremely flammable
and explosive.
Fire or explosion can cause severe burns or
death.
When Starting Engine
• Ensure that spark plug, muffler, fuel cap and air
cleaner (if equipped) are in place and secured.
• Do not crank engine with spark plug removed.
• If engine floods, set choke (if equipped) to OPEN/
RUN position, move throttle (if equipped) to FAST
position and crank until engine starts.
1. Check the oil level. See the
How to Check/Add Oil
section in the Engine Manual.
2. Make sure equipment drive controls are disengaged.
3. Move the throttle control to the FAST position.
Operate the engine in the FAST position.
4. Turn the electric start switch to the ON/START
position.
NOTE: If the engine does not start after repeated
attempts, go to
BRIGGSandSTRATTON.COM
or call
1
-
800
-
233
-
3723
(in USA).
NOTICE: To extend the life of the starter, use short
starting cycles (five seconds maximum). Wait one minute
between starting cycles.
Not
for
Reproduction
Summary of Contents for 2690817
