LADDER SYSTEM ASSEMBLY INSTRUCTIONS
A
. Attach upright posts with brackets to top of ladder using M10 x
40mm screws, flat washers and nyloc nuts. Torque set to 18N/m.
B
. Install GRP step at top of ladder, securing using M10 x 40
screws, flat washer and nyloc nuts. Torque set to 18 N/m.
C
. Attach large hoops to top and lower of upright posts as sown
above using M10 x 80mm screws, flat washers and nyloc nuts.
Torque set to 18 N/m
D
. Attach aluminium upright tube between to two large hoops
using M10 x 50mm screws, flat washers and nyloc nuts. Torque
set to 18 N/m.
E
. Connect upright return post between to two uprights using
A10-7, 15-7 and short length of tubes. To secure A10-7, push pin
through fitting. Torque set to 39 N/m.
F
. Attach hoops to upright stile on ladder posts threading M10 x
40mm screws through predrilled holes, securing with flat washers
and nyloc nuts. Torque set to 18 N/m.
Summary of Contents for Easi-Dec
Page 15: ......
