SimpliFire • SF-ALL40-BK, SF-ALL48-BK, SF-ALL60-BK, SF-ALL84-BK • 2040-981 Rev. M • 7/21
18
B. Operating by Remote Control
• The appliance Main Power Switch must be in the “ON”
position for the remote control to function.
• Make sure batteries are properly installed in Remote
Control.
- Battery requirements 2 x AAA batteries
(included).
•
The effective range of the remote is up to 16 ft.
• The remote control must be within the 16 ft. range and
also be pointed directly at the face of the appliance.
For best results, position the remote control within 45
degrees of the face of the appliance
ICON
TITLE
FUNCTION
REMOTE
LCD DISPLAY
FIREPLACE RESPONSE
POWER
The POWER button will turn the
fireplace on. It will also put the
fireplace in a standby mode.
This will turn off all functions at
once but will hold the settings in
memory except Timer function.
The unit will turn on at the same
settings by pressing the power
button again.
LCD illuminates
and displays flame
status Icon and
temperature set
point.
Fireplace emits single audible beep
to confirm command to transition to
ON or STANDBY state.
FLAME
By pressing the FLAME button,
the unit will cycle through four
flame effects.
LCD illuminates
and displays flame
status icon.
Fireplace emits single audible beep
to confirm command to transition
between four FLAME states.
HEATER
Press Heater button once, heater
turns on LOW.
Press Heater button twice, heater
turns on HIGH.
Press Heater button three times,
heater turns off.
LCD illuminates
and displays
heater status icon.
Fireplace emits single audible
beep to confirm command to
transition between HEATER states.
Fireplace displays one red LED for
10 seconds to confirm low heater
command. Fireplace displays two
red LED for ten (10) seconds to
confirm high heater command.
THERMOSTAT
Pressing the Temperature button
adjusts the heaters response
to the ambient temperature
conditions in the room.
Temperature adjusts from 16 °C
- 28 °C (60 °F - 84 °F). Power
button must be on to set °C to °F.
Hold for 3 seconds and the LCD
display from °C to °F.
Remote displays
the temperature.
If in Stand-by
mode, temperature
displays but
cannot be
adjusted.
Fireplace emits single audible beep
to confirm command to change
desired temperature set point.
TIMER
Pressing the Timer button sets
the time desired for the fireplace
to run. The Timer can be set from
.5 hour up to nine (9) hours in one
(1) hour increments.
Remote will
display the time
setting selected. If
in Stand-by mode
time will display
but cannot be
adjusted.
LIGHT
Pressing the Light button changes
the ember bed colors (14 color
themes available - 13 colors and
a color rotating option), and turns
it on/off.
No indicator.
