SimpliFire • SF-ALL48-BK, SF-ALL60-BK Service Manual • 2040-960 Rev. B • 3/18
10
Masonry Wall
• In the marked locations, drill 5/16 in. diameter x 2 in.
deep holes. See Figure 30.
• Insert the provided wall anchors into the holes.
• Gently tap the anchors with a hammer until they are
flush with the wall surface.
• With mounting hooks pointed up, attach the bracket
to the masonry anchors with ST5X40 screws . See
Figure 31.
Figure 29. Installing Anchors in Hollow Wall
Figure 28. Toggle Bolt Installation through Mounting Bracket
Wall
Masonry Anchors
Figure 30. Masonry Anchor Placement
Figure 27. 3/16 Toggle-Bolt Anchor
• The toggle-bolt anchors are provided to accomodate
the required anchor points based on the appliance.
Use of toggle bolt anchors requires drywall thick-
ness of minimum 1/2 in. and drilled holes size of
5/16 in. diameter.
• Insert the bolt through the front side of the mounting
bracket and thread the toggle onto it from the rear of
the bracket. See Figure 28.
•
Fold the toggle wings flush against the bolt and push
them through a drilled hole until the toggle wings
expand open on the other side. See Figure 29.
• Pull back on the bolt and tighten. See Figure 29.
Note:
This product cannot be installed on a wall
sheathed with drywall less than 1/2 in. thick, unless
all six (6) anchor points in the mounting bracket
align with structural framing members.
WARNING! Risk of Damage or Personal Injury!
Al-
lowable pull-out and shear strength are 25% of ultimate
values or less, as required by building authorities.
Framed Wall
• Locate the mounting bracket on the wall in the
desired location of the appliance. Level the bracket,
then mark its location on the wall, including a mark-
ing for each of the fastener holes in the bracket.
• For each of the marked mounting point locations,
determine which points align with a structural fram-
ing member.
• At the points where a wood or metal framing mem-
ber exists, the ST5X40 screw can be installed
directly into that structural member.
• For every mounting hole that does not align with a
structural framing member, a wall board toggle-bolt
anchor must be used. See Figure 27.
Direct Wall Mounting with Wall Mounting
Bracket
The wall mounting bracket can be installed on masonry
walls such as those constructed of brick or concrete,
or to framed walls constructed of wood or steel framing
sheathed with gypsum wallboard, drywall, wood, etc.
The method used to mount the mounting bracket is dif-
ferent between masonry walls and framed walls. Refer
to the following sections for more detail on the method
applicable to this installation.
