SimpliFire • SF-ALL48-BK, SF-ALL60-BK Service Manual • 2040-960 Rev. B • 3/18
8
Motor Installation
The motor is located in the lower right corner of the
appliance.
15. Remove the rubber shaft on the motor. See
Figure 18.
Figure 18. Rubber Shaft Removal
RUBBER
SHAFT
16. Remove the two screws on the motor. See
Figure 19.
Figure 19. Remove Motor Screws
SCREWS
17. Unplug the motor cable connection. See Figure 20.
Figure 20. Unplug Motor Cable
18. Install replacement part and reverse the installation
steps.
Flame LED Light Board Installation
NOTE: The following steps (15-18) are only for re-
placement of the motor.
If replacing Flame LED Light Board, continue onto
step 19.
19. Remove screws used to attach the flame screen
bracket. See Figure 21.
SCREW LOCATION
Figure 21. Remove Flame Screen Bracket Screws.
20. Remove flame screen bracket.
21. Unplug cable connection on each end of the LED
Board. See Figure 22.
Figure 22. Unplug LED Board Cable Connections
CABLE CONNECTION LOCATION
22. Install replacement part and reverse the installation
steps.
FLAME SCREEN
BRACKET
