SimpliFire • SF-ALLP50-BK, SF-ALLP60-BK, SF-ALLP72-BK Service Manual • 2044-960 Rev. C • 10/19
4
LED Light Board Installation
The LED Service Kit includes LED Light Boards for both
the Fuelbed and the Flame effect.
Determine which LED light set to be installed. See
Figure 7.
Figure 7 LED Light Board Identification
LED FOR
FUELBED
1. Complete Steps 1-6 in Preparation for Component
Installation instructions.
2. Locate the Fuelbed LED Light Board cable. See
Figure 8.
LED LIGHT BOARD CABLE
3. Unplug the LED Light Board cable. See Figure 9.
LED LIGHT BOARD CABLE
Figure 8 LED Light Board Cable
Figure 9 Unplug LED Light Board Cable
4. Remove the LED light board from the bottom isolation
columns. Starting at one end of the board use a
needle-nose pliers to compress the plastic barbs from
each isolation column as each plastic barb is
compressed, disengage the LED light board from
each barb. See Figure 10.
ISOLATION COLUMNS
Figure 10 Isolation Columns
5. Remove and discard LED light board, replace with
new LED light board. Install new LED light board
by engaging the holes in the light board with the
plastic barbs, and pressing into position. Reconnect
the cables. See Figure 9.
Fuelbed LED Light Board Installation
LED FOR
FLAME
(APPLIANCE MAY VARY)
