5
SimpliFire • SF-ALLP50-BK, SF-ALLP60-BK, SF-ALLP72-BK Service Manual • 2044-960 Rev. C • 10/19
Touch Button Installation
1. Complete Steps 1-6 in Preparation for Component
Installation instructions.
ST3X8 SCREWS
(STEPS 2 & 7)
2. Remove the front two (2) ST3X8 screws on the
Touch Button Assembly..
Figure 11 Touch Button Assembly
3. Unplug the touch button wire connector and remove
the Touch Button Assembly. See Figure 11.
4. Remove the two (2) screws holding the touch button
assembly to the plastic housing. See Figure 12.
SCREWS
(STEPS 4 & 6)
Figure 12 Touch Button board - Plastic Housing
5. Remove the Touch Button board from the plastic
housing.
6. Replace the Touch Button Assembly by installing the
new Touch Button Board in the plastic housing with
button cover. Fasten with two (2) screws.
7 Reinstall the Touch Button Assembly and housing by
reconnecting the wire connector and refastening in
place with two (2) screws.
Glass Screen Panel, Receiver Board, Control
Board, Heater, Rotisserie, Motor, Flame LED
Light Board Installation
1. Complete Steps 1-6 in Preparation for Component
Installation instructions.
REMOVE SCREWS
2.
Remove screws holding the screen fixing bracket.
See Figure 13.
Figure 14 Glass Screen Panel Removal
4. After these steps, the heater assembly, control board
assembly and reciever board may be replaced.
3. Carefully remove the Glass Screen Panel. Rotate
the top edge of the glass panel towards the opening,
then lift out the the glass panel from the appliance.
Set glass panel aside in a safe location, preferably a
soft surface such as carpet or cardboard. See
Figure 14.
Figure 13 Remove Fixing Bracket Screws
