SimpliFire SF-ALLP50-BK, Service Manual

SimpliFire •  SF-ALLP50-BK, SF-ALLP60-BK, SF-ALLP72-BK Service Manual  •  2044-960  Rev. C  •  10/19

8

Note:

  Flame Screen and Rotisserie must be removed  

           before Motor replacement can be completed. 
1.  Remove three (3) ST4X8 screws on the Motor 

     Bracket.  See Figure 22.
2.  Unplug the wire connector.     

Motor Installation

(3) ST4X8 

SCREWS

      WIRE 

CONNECTOR

Figure 22  Motor Removal

3. Install new Motor by following the removal steps  

    in reverse order. 

Flame LED Light Board Installation

1. Remove screws used to attach the flame screen

    bracket.  See Figure 22.

FLAME SCREEN 

BRACKET SCREWS

Figure 23  Remove Flame Screen Bracket Screws.   

2.  Remove flame screen bracket.

3.  Unplug cable connection on each end of the LED  

     Board.  See Figure 23. 
4.  Release the LED boards from plastic retainers.  See  

     Figure 24.

Note:

 Some retainers may require releasing an adhesive  

    prior to removal. 

Figure 24  Unplug LED Board Cable Connections   

CABLE CONNECTION LOCATION

5. To install replacement part reverse the installation 

    steps.  

Note:

   Flame Screen and Rotisserie must be removed  

            before LED Light Board replacement can be 

            completed. 

LED BOARD RETAINERS