SimpliFire SF-ALLP50-BK, Owner'S Manual

11

SimpliFire  •  SF-ALLP50-BK, SF-ALLP60-BK, SF-ALLP72-BK  •  2044-980  Rev. C  •  10/19

Figure 4.10  Optional Power Cord Assembly (Only for Direct Wall Mount Installation)

C.  Electrical Connection / Installation

Note: All wiring must be completed prior to finishing 

the unit.
All electrical connections shall be performed by a 

qualified electrician.

WARNING! Risk of Fire, Electrical Shock and Injury! 

Electrical wiring must comply with local building electri-

cal codes and the latest edition of the NFPA 70 National 

Electric Code (NEC) other applicable regulations.

WARNING! Risk of Shock! 

Label all wires prior to dis-

connection when servicing the appliance. Wiring errors 

can cause improper and dangerous operation.  Verify 

proper operation after servicing.

This appliance has been designed to be hard-wired for 

120VAC.  A supplied plug-in kit is also available for use 

with a grounded receptacle.
A 15 AMP, 120VAC/60Hz circuit is required. Additional 

appliances on the same circuit as this appliance may ex-

ceed the current rating of that circuit. A dedicated circuit 

is not required, but is strongly recommended to prevent 

circuit breaker trips or fuse failure.

Hard-Wired Installation

:

Note

:  The appliance must be electrically connected and 

           grounded in accordance with local building elec- 

           trical  codes.
1.   Remove terminal block cover plate located on the  

      right end of the appliance. 
2.   Install a wire strain relief bushing into the cover  

      plate.

3.   Terminate type NM-B wire to the terminal block, 

      ensure connections are secure, and tighten the  

      strain relief. Use 3/32 slotted heat screwdriver, or 

      equivalent, to depress the spring loaded terminals  

      for the conductors. 
4.   Replace terminal block cover plate and retaining  

      screws.

WARNING!  

Risk of Fire, Electrical Shock and Injury! 

Ensure the power cord is not installed so that it is pinched 

or against a sharp edge and ensure that the power cord is 

stored or secure to avoid tripping and snagging.

Power Cord Installation

The appliance power cord has a three pin NEMA-5-15P 

plug.  The power cord should not be used unless a 

grounded receptacle is available.
1.  Remove the terminal block cover plate located on  

     the right end of the appliance.
2.  Disconnect the terminal block from the three wires  

     inside the appliance.  Wires are released by discon- 

     necting the three conductor wire connector.  Discard  

     the terminal block cover plate. 
3.  Connect the three conductor wire connector to the  

     connector on the block supplied with the power cord  

     kit.  See Figure 4.10. 
4.  Replace cord kit terminal block cover plate  

     and retaining screws.  Plug cord into nearest outlet. 

     See Figure 3.3.

L

N

RED

 YELLOW / GREEN

BLUE

Wire Diagram