1
SimpliFire • SF-SC43-BK, SF-SC55-BK, SF-SC78-BK Service Manual • 2041-960 Rev. B • 9/19
SERVICE MANUAL
Glass Front, Media, LED Light Boards (Ember Bed and Flame), Remote Receiver,
Rotisseire, Motor, Control Board, Blower/Heater, Reflective Side Panels & Mounting Bracket
Model: SF-SC43-BK, SF-SC55-BK, SF-SC78-BK
- Instructions -
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during
installation and service. Sheet metal edges are sharp.
Leave this manual with party responsible for use
and operation.
NOTICE! DO NOT discard this manual.
Important service
and maintenance instructions included.
NOTICE! DO NOT discard any hardware while
servicing.
It may be reused.
WARNING! Risk of Shock!
Always turn off the circuit
breaker before moving or servicing.
Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
Tape measure
Needle-nose pliers
Hammer
Gloves
Level
Magnetic Phillips screwdriver
Safety glasses
Drill
Flat blade screwdriver
Phillips Tip-Bit socket and ratchet (for Blower/Heater)
CAUTION! Two adults recommended for the removal
or installation of glass front.
Use caution when han-
dling glass. Failure to do so could result in personal injury
or property damage.
WARNING! Risk of Personal Injury or Property Dam-
age!
Failure to follow instructions below may result in
damage to the equipment and / or may expose the user
to the risk of fire, serious injury, illness or death.
Front Replacement
Remove Front and Trim Assembly
1.
Pull firmly on the top edge of the Clean Face Front
until it rotates away from opening of the appliance,
then lift off of the appliance. See Figure 1.
2. To re-install, align the front with the opening around
the appliance and press firmly onto appliance until
the front is flush with wall and magnet engage with
appliance.
Trim Ring Replacement
1. Remove the Front. See Front replacement instruc-
tion.
2. Remove the Trim Ring from the front by remov-
ing the screws that attach the two parts. See Figure
1. Carefully disengage the Trim Ring and remove it
from the Front.
3. With the new Trim Ring set on the floor face down,
set the front inside the Trim Ring face down. Re-
install the screws. See Figure 1.
4. Re-install the Clean Face Front.
Figure 1. Trim Ring / Front
TRIM RING
FRONT
