SimpliFire • SF-SC43-BK, SF-SC55-BK, SF-SC78-BK Service Manual • 2041-960 Rev. B • 9/19
6
Rotisserie Assembly and Rotisserie Motor
Replacement
1. Remove Front and Trim Assembly, see Front
replacement instruction.
2. Remove Glass, see Glass replacement instruction.
3. Access internal components, see Accessing Internal
Components instruction.
4. Remove the Flame Screen, see Flame Screen
Replacement instruction. Only remove Flame
Screen if replacing back Rotisserie.
5. Remove screws from the Rotisserie center supports.
See Figure 17.
6. Disengage rotisserie rods from motors located in
right side of cavity. Use hand to shift the rotisserie
rod to the left until the rubber coupler on the right
end disengages from the motor shaft and lift out of
appliace. See Figure 18.
7. Remove two screws that attach each motor to the
motor brackets. See Figure 18.
8. Remove each motor until the electrical connector is
visible. See Figure 19.
9. Disconnect the electrical connector to the motor.
See Figure 19.
10.
Connect the new motors to the electrical connectors.
11. Install the replacement motors on the brackets, 2
screws each. See Figure 17.
12. Install the replacement rotisserie rod. Install the left
end of the rod into the bushing in the left rear of the
cavity. Align the rubber coupler with the motor shaft.
Shift the rod to the right until the rubber coupler fully
engages the motor shaft. Re-attach center reflector
rod supports, 1 screw each. See Figure 15.
13. Re-install components removed to access internal
components, see Accessing Internal components
instruction.
14. Re-Install glass.
15. Re-Install Front and Trim Assembly.
Figure 17
Figure 18
Figure 19
CENTER SUPPORT
SCREWS
COUPLERS
CONNECTION
