SimpliFire • SF-SCT43-BK, SF-SCT55-BK Service Manual • 2043-960 • 7/20
2
Heater Assembly Replacement
1. Remove glass, see Glass Front Replacement
instruction.
2. Support the Heater Assembly and remove 4 screws.
See Figure 2.
3. Slowly lower Heater Assembly until cable connector
is accessible. See Figure 3.
4. Disconnect Heater Assembly cable connector. See
Figure 3.
5. Connect replacement Heater Assembly. See Figure
3.
6. Re-install Heater Assembly into appliance, be
careful not to pinch any wires.
7. Re-Install 4 screws.
8. Re-Install glass per Glass Front Replacement.
Figure 2 Heater Assembly
Figure 3 Heater Connector
Control Board Replacement
1. Remove glass, see Glass Front Replacement
instruction.
2. Support the Control Board Assembly and remove 4
screws. See figure 4.
3. Slowly lower Control Board Assembly until cable
connectors are accessible. See Figure 5.
4. Disconnect the seven separate connectors attached
to the Control Board Assembly and re-connect
the seven connectors to the new Control Board
Assembly. See Figure 5.
5. Re-install Control Board Assembly into appliance, be
careful not to pinch any wires.
6. Re-Install 4 screws.
7. Re-Install glass per Glass Front Replacement.
Figure 4 Control Board Location
Figure 5 Control Board Removal
HEATER ASSEMBLY
HEATER ASSEMBLY
CONNECTOR
CONNECTOR
= SCREWS
= SCREWS
= SCREWS
