REV110619
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 | info@simpliphipower.com |
SimpliPhiPower.com
| 35 |
5.0
– Programming
5.1
– Depth of Discharge
The AccESS Sol-Ark comes pre-programmed for a maximum 80% depth of discharge (DoD) on the PHI
batteries. This qualifies the batteries for the 10-year / 10,000 cycle Warranty.
To change the
batteries’ DoD to the 5,000-cycle Warranty or 3,500-cycle Warranty, modify the State of
Charge (SoC) percentages as outlined in this Operating Parameters section of this Manual.
If a firmware update is executed on the AccESS, please verify all PHI custom settings are still in place.
5.2
– Operating Parameters Per Warranty
Inverter/Charge Controller Settings
For online programming guidance, refer to Sol-
Ark’s
Menus and Programming
video
https://www.youtube.com/watch?v=mcXXzgfRT90&t=1497s
) when programming those settings outlined
in Table 2.0 on the following page.
Press the gear icon to get to the
Settings
menu (Figure 19.0), then press
Battery Setup
(Figure 20.0) to
program the parameters in Table 2.0.
Figure 19.0
– Sol-Ark Home Screen (Touchscreen)
Figure 20.0
– Sol-Ark System Setup Screen
