Getting Started DKIT-05
Landscape-Outdoor Lighting Kit
Simply Automated, Incorporated
6108 Avenida Encinas, Suite B, Carlsbad, CA 92011 USA
Technical Support:
www.simply-automated.com
or
800-630-9234
452-0001-0005WEB Rev. B Revised: September 22, 2011
2
Simply Automated Pre-Configured SimplySmart
TM
Series
Utilizes SimplySmart
TM
technology to make installation a breeze.
No computer programming required!
Simple-n-easy, ready to use lighting control.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic safety precautions should always be followed, including the following:
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2.
Keep away from water. If product comes into contact with water or other liquid, disconnect immediately.
3.
Never use products that have been dropped or damaged.
4.
Do not use this product outdoors, unless protected by a weatherproof enclosure.
5.
Do not use this product for other than its intended use.
6.
Do not connect multiple loads that, when combined, exceed the maximum load rating of the product.
7.
To avoid risk of fire, burns, personal injury and electric shock, install this product out of reach of small children.
8.
Do not install in areas that can exceed 120°F (e.g., in an attic).
9.
Do not cover the product with any material when in use.
10. This product uses polarized plugs and sockets (one blade is wider than the other) to reduce the risk of electric shock. These plugs and
sockets fit only one way. If they do not fit, consult a technician. Do not use with an extension cord unless plugs can be fully inserted. Do
not alter plugs.
11.
SAVE THESE INSTRUCTIONS.
DKIT-05 Outdoor-Landscape Relay Starter Kit
Includes 2 Appliance (relay) Modules and 1 Scheduler-Timer Controller
Getting Started
Section 1: Very Important Pre-Installation Notes
•
Your home should be no more than 2500 square feet and have only one breaker panel. A phase coupler is
required in some home installations; especially homes > 2500 square feet or homes with more than 1
breaker panel. See Section 6 for more information.
•
Not intended for use in multi-dwelling (condo, apartment) buildings with 3-phase power.
•
Do not reset to factory default configuration, pre-configured settings will be lost.
•
UPStart
software and a
computer interface module
or Scheduler-Timer can be used with a PC for
customizing pre-configured units and checking performance.
Section 2: Installation of Appliance (relay) Modules and Scheduler-Timer Controller
Find a convenient location you would like to use for the Scheduler-Timer (e.g. outlet in garage, office, kitchen or
closet) and plug in the Scheduler-Timer controller. Locate 2 electrical loads you would like to turn ON/OFF with
the relay modules, such as outdoor low-voltage lighting transformers, appliances, pump/motors or lights. Plug a
relay module into a wall outlet (or the outlet used for a timer in the outdoor lighting transformer). Next, the power
cord of the electrical load (transformer) to be controlled plugs into the socket on the bottom of the appliance
module. Note, the convenience outlet on the front of the appliance module is always ON and is not ON/OFF
controlled. If there is an ON/OFF switch on the plugged in electrical load, then turn the load switch ON. Repeat
this process for second relay module. You're done with the installation process! If necessary, please refer to the
User Guide enclosed in the Appliance Modules product box or see
http://www.simply-
automated.com/documents/452-0013-0101_RevF_UMA_UserGuide_090512.pdf
.
