18
ASSEMBLY PROCEDURES
(cont’d)
12. Leak Check.
Leak Testing Diagram for areas to check:
5
- 13 -
11. Connect the gas hose and regulator after that
connect the regulator to the gas cylinder.
WARNING!
Ensure the hose does not contact
any high temperature surfaces, or it may melt
and leak causing a fire.
After the cylinder is placed inside the heater, secure
the cylinder with block belt tightly.
12. Leak Check.
11
12
Regulator / Cylinder
Hose / Regulator
WARNING!
WARNING!
12
Hose / Regulator
connection
Regulator / Cylinder
connection
5
In the event of any defaults or problems of assembly or use, please don’t try to modify it by yourself, contact
your supplier or distributor.
PROBLEMS CHECK LIST
PROBLEM
PROBABLE CAUSE
SOLUTION
Pilot will not light
Gas valve may be OFF
Tank fuel empty
Opening blocked
Air in supply system
Loose connections
Turn the gas valve ON
Refill LPG tank
Clean or replace opening
Purge air from lines
Check all fittings
Pilot will not stay on
Debris around pilot
Loose connections
Thermocouple bad
Gas leak in line
Lack of fuel pressure
Clean dirty area
Tighten connections
Replace thermocouple
Check connections
Tank near empty. Refill LPG tank.
Burner will not light
Pressure is low
Opening blocked
Control not ON
Thermocouple bad
Pilot light assembly bent
Not in correct location
Tank near empty. Refill LPG tank.
Remove and clean
Turn valve to ON
Replace thermocouple
Place pilot properly
Position properly and retry
Pyramid Gas Patio Heater_IM_Wowcher_A4.indd 18
Pyramid Gas Patio Heater_IM_Wowcher_A4.indd 18
12/05/2021 13:15
12/05/2021 13:15
