S T E P 1
Set Up
Carefully remove umbrella parts from box and lay on a soft clean surface.
Insert reducer into stem of base (sold separately). Insert bottom pole into base stem
(Fig. 1) and tighten base stem knobs to secure umbrella in place. Assemble bottom
pole knob to bottom pole with small locking screw and washer (Fig. 2). Turn bottom
pole knob clockwise to tighten.
From canopy structure, untie middle canopy tie. Assemble top pole to middle strut by
inserting large locking screw into joint mechanism and tighten with washer and joint
knob (Fig. 3).
Lift assembled top pole and insert into bottom pole (Fig. 4). NOTE: Loosen bottom
pole knob by turning counter clockwise if top pole does not easily slide into bottom
pole.
2
5
(Fig. 2)
S T E P 5
Close Umbrella
To close canopy, loosen joint knob by turning counter clockwise and bring canopy to a
horizontal position (Fig. 14). Turn joint knob clockwise to secure in place. One at a
time, press slider car handle to disengage (Fig. 15). Slide slider cars one at a time,
inward until canopy is fully closed.
Turn joint knob counter clockwise and turn canopy to an upright vertical position. Turn
joint knob clockwise to secure umbrella position (Fig. 16). Loosen bottom pole knob by
turning counter clockwise and carefully guide top pole down into bottom pole (Fig. 17).
Tighten bottom pole knob by turning clockwise (Fig. 18). Tie 3 canopy ties to secure
canopy. Slide protective cover over umbrella (Fig. 19) to protect your umbrella year
round.
(Fig. 14)
(Fig. 15)
(Fig. 16)
(Fig. 17)
(Fig. 18)
(Fig. 19)
(Fig. 3)
(Fig. 4)
Bottom Pole
Bottom
Pole Knob
Top Pole
Joint Knob
Middle Strut
(Fig. 1)
