2.
Operating Instructions
Before the MegaDumper is used for the first time, a Hazard and Risk Assessment should be
completed as per
. The cradle may also need to be adjusted as per
2.1
Before use
Before operating a MegaDumper, check the following points to ensure that the machine is
stable and safe to use:
1.
The machine is on firm ground, with a slope ratio less than 1:12.
2.
All covers and safety guards are in place.
3.
The wheel brakes are applied, and/or the feet are wound down onto the ground.
4.
All personnel other than the operator are well clear of the machine.
5.
The cradle is fully lowered.
6.
The key is inserted and turned to the ON position.
7.
The battery indicator (if fitted) shows an acceptable level of charge.
2.2
Emplacing and removing bins
The MegaDumper cradle is designed to allow bins to be emplaced and removed easily,
while also holding them securely throughout the tipping cycle.
Cradle identification
A range of different cradles may be fitted to the MegaDumper, depending on the types of
bin that the machine needs to empty. Use the following table to identify the correct
instructions for your machine.
It is important to understand how to correctly emplace bins onto the cradle. Bins that are
not correctly emplaced may come loose and damage the machine while being lifted,
or fall out when inverted.
Cradle Type Primary Use
Bin Compatibility
Cradle Image
Refer
Type-S
(Short
EN840
base-lift
cradle)
General waste
and recycling
applications
EN840 mobile
garbage bins
(wheelie
bins)
-
60L
-
80L
-
120L
-
140L
-
240L
-
660L
