2.3
Operating the controls
The MegaDumper controls are designed to allow safe, intuitive operation of the machine.
Control Panel identification
The MegaDumper may be fitted with a variety of different controls, depending on the
operational and safety requirements of the machine. Use the following table to identify the
correct instructions for your machine.
It is important to understand how to use the controls correctly, as improper operation
may result in a safety hazard or damage to the machine.
The control panel is normally atop the powerpack cover, but on some models, it is
mounted onto a separate enclosure.
Control
Panel Type
Primary Usage
Controls
Image
Refer
Standard
Standard
machines
-
RAISE/LOWER
-
KEY SWITCH
-
VOLTMETER (battery
machines only)
Autocycle
Machines with an
autocycle
controller
-
RAISE/LOWER
-
EMERGENCY STOP
-
CONTROL MODE
(AUTO/MANUAL)
VSD
Machines with a
Variable Speed
Drive controller
-
JOYSTICK FOR
RAISE/LOWER
-
KEY SWITCH
Safety-
Monitored
Machines with
safety-monitoring
systems to comply
with 13849-1:2015
and AS/NZS4024
up to CAT3/CAT4
-
RAISE/LOWER
-
EMERGENCY STOP
-
CONTROL MODE
(AUTO/MANUAL)
-
SAFETY RESET
-
Panel describing
the architecture of
the safety-
monitoring systems
(CAT3/CAT4)
Example Only
