4.
Press and hold the RAISE button
until the bin reaches the inverted position, then
release. Wait for the contents of the bin to empty.
Release the RAISE/LOWER button or press the EMERGENCY STOP button to stop the cradle
at any time.
5.
Press and hold the LOWER button
until the cradle returns to the ground.
6.
Open the door and remove the empty bin as per
7.
Repeat from step 1) as required.
VSD Control Panel
How to operate the controls of a VSD machine,
with a joystick to allow progressive control of
the lifting speed.
1.
Before operation, check that the machine is
stable and safe to use as per
2.
Open the door and place the full bin onto the cradle, taking care that it is properly
positioned as per
, then shut the door.
3.
Push the JOYSTICK FULLY FORWARD
to begin lifting the bin.
4.
When the bin reaches the top of the mast and starts to invert,
gently move the
JOYSTICK SLIGHTLY BACK
so that the material is poured from the bin in a controlled
manner, as desired
.
Wait for the contents of the bin to empty.
Release the JOYSTICK to stop the cradle at any time.
5.
Pull the JOYSTICK FULLY BACK
until the cradle rests on the ground.
6.
Open the door and remove the empty bin as per
7.
Repeat from step 1) as required.
Safety-Monitored Control Panel
How to operate a machine with a safety-
rated PLC control unit and CAT3/CAT4
monitoring system.
MegaDumper models that are fitted with a
safety-monitored control system may be used in
either MANUAL or AUTO mode, selected using a
switch on the control panel.
The operating procedure for each mode is as follows:
2.3.5.1
AUTO mode
1.
Before operation, check that the machine is stable and safe to use as per
2.
Open the door. If the door is locked, press the LOWER button to unlock it.
3.
Place the full bin onto the cradle, taking care that it is properly positioned as per
then shut the door.
4.
Turn the mode-selector switch to AUTO.
5.
Press and hold the blue RESET button for two seconds.
