Warning & Caution
SimPure
®
products are designed with safety in mind. However,personnel
working on these units must be familiar with any potential dangers. All
safety information detailed in this handbook should be reviewed before
installing and operating this water purification system.
This product is not a toy, please keep children away from the
System or use under adult supervision. Please keep packing
materials out of children's reach.
The System has been designed for indoor use only. Install the System
out of direct sunlight and secure it to a vertical surface such as a wall
or inside a cupboard at ambient room temperature.
Do not move the System without first shutting off the water supply,
draining, and releasing the water pressure.
This unit is for use with cold municipal tap water or potable well
water that has been tested safe by a certified laboratory. Never use
hot water or unknown/unsafe sources of water.
The installation of the System must comply with your local and
state regulations. Please check before commencing installation.
In case of malfunction, shut-off the water supply to the System.
If any part of the System is damaged or missing, replace the item
before use.
Warnings and Cautions are provided; Failing to observe the
instructions could result in damage to the equipment,
associated parts, surroundings, or personal injury.
Operating Guidelines
The following table lists the operating parameters for this product. Operating
this product outside these specifications may cause system performance issues
and may even lead to personal injury and void any warranty. Please contact
SimPure
®
for further advice and support if unsure about the requirements.
Operating Parameters
Model
SimPure
®
T1-400 & T1-400UV
Maximum Flow Rate
400 Gallons per day
Note:
Dependent on feedwater type, operating
pressure and water temperature.
Power Requirements
110 Volts 60Hz AC. 6Watts
Feed Water Type
Municipal Potable/Tap water or Well water
meeting government drinking water
standards
Feed Water Pressure
15 -60 PSI
Note
：
Install a pressure regulator if
exceeding this feed water pressure
Feed Water Temperature
41-100℉ (5-38℃)
Ambient Temperature
40-104℉ (4-40℃)
Feedwater TDS* level
≤ 500 ppm
UV Light
UV wavelength range
：
270~280nm
UV dose
：
8600uJ/cm²
Water Hardness
(Optional)
For best results use a softened feedwater
supply with a hardness level below
10 gains per gallon, with no iron present.
* TDS = Total Dissolved Solids, which is the total weight of all solids dissolved in a given volume of water, expressed in units of mg per
unit volume of water (mg/L), also referred to as parts-per-million (ppm). With a SimPure
®
TDS meter, you can easily compare the
system outlet quality with your source water to help monitor the performance of the system
3
4
