Health & Safety
SimPure
®
products are designed with safety in mind. However, personnel
working on these units must be familiar with any potential dangers. All
safety information detailed in this handbook should be reviewed before
installing and operating this water purification system.
This product is not a toy; children must be supervised when
using the system. Keep packing materials out of children’s
reach.
The system has been designed for indoor use only. Install the
system out of direct sunlight on a flat, level dry, and secure
surface or mounted securely in a location with average
ambient room temperature.
Do not move the system without first isolating the feed water,
draining, and releasing water pressure.
This unit is for use with cold municipal tap water or potable
well water that has been tested safe by a certified laboratory.
Never use this unit with hot water or unknown/unsafe
sources.
The installation of the system must comply with your local and
state regulations. Please check before commencing installation.
In case of malfunction, isolate the water supply to the system.
If any part of the system is damaged or missing, replace the
item before use.
Warnings! and Cautions! are provided; Failing to observe
the instructions could result in damage to the equipment,
associated parts, surroundings, or personal injury.
Operating Guidelines
The following table lists the operating parameters for this product.
Operating this product outside these specifications may cause system
performance issues and may even lead to personal injury and void any
warranty. Please contact SimPure
®
for further advice and support.
Operating Parameters
Model
SimPure
®
T1-5
Production rate (up to)
Dependent on feedwater type, operating
pressure and water temperature.
Model: 75GPD: 75 Gallons per day (283L)
Model:100GPD: 100 Gallons per day (378L)
Power requirements
Not applicable, this product only requires
water pressure to operate.
Feedwater Type
Municipal potable/tap water or Well water
meeting government standards
Feedwater Pressure
Ideal feedwater pressure should be
between 40 and 80 psi (275 to 550 kpa)
Pressures below 40 psi will slow down the
water production, and a booster pump may
be required.
The maximum system operating
pressure is 85 psi (600kpa).
Install a pressure regulator if
exceeding this feedwater pressure
Feedwater Temperature
40-
100℉ (
4-38
℃)
Ambient Temperature
40-
104℉
(4-
40℃)
Feedwater TDS* level
≤ 500
ppm
Water Hardness
(Optional)
For best results use a softened feedwater
supply with a hardness level below
10 gains per gallon, with no iron present.
* TDS = Total Dissolved Solids, which is the total weight of all solids dissolved in a given volume of water, expressed in
units of mg per unit volume of water (mg/L), also referred to as parts-per-million (ppm). With a SimPure
®
TDS meter,
you can easily compare the system outlet quality with your source water to help monitor the performance of the system.
3
4
