CP33 Position menu
Chapter 4-3
Position setup
ENT
From position display, press [ENT] to load Position setup:
Datum: 000: World Geodetic System 1984
Reset log:
Log 1: 00000.0nm
Log 2: 00000.0nm
Display position as: LAT/LON
Delta position: 0°00.000N 0°00.000E
Start position: Lat 57°02N Lon 009°50E
Speed and course filter level: 3
Display speed as: SOG
Course and bearing as: MAGNETIC
Altitude mode: AUTO
Manual antenna altitude: +005 m
Display depth in position display: NO
Time: UTC
Time: 13:43:56 Date: 14-02-2002
Go to the function you wish to change
CLR
Reset log
0-9
Key in new values, or...
+/-
Toggle between available values
ENT
Confirm editing and return to the Position display
Datum
- is preset to WGS 1984 (World Geodetic System 1984), but
can be changed to any of the 118 datums listed in Appendix B e.g.
to match old paper charts or trackplotter data from RS2500/RS4000
(datum #002 European 1950).
The position in the position display and NMEA output (GLL+GL2)
will refer to the selected datum. To select a new datum: place the
cursor next to “Datum” and key in a new number or go two spaces to
the right (00
0
) and leaf through the datum list with +/-.
The datum in the chart display is fixed i.e. WGS84.
Summary of Contents for CP33
