CP33 Pilot menu & navigation examples
Chapter 6-9
6.3 Anchor guard
MENU
Call up the menu bar, and...
4,5
activate the anchor guard function
-the chart display will provide an impression of the vessel’s position
in relation to the alarm circle.
To check/change the preset alarm distance:
MENU
Call up the menu bar, and...
4,1
load the highway display
ENT
enter the navigation setup display
Move cursor to the Anchor alarm distance
0-9
Enter new value with numeric keys
ENT
Confirm the change
To turn Anchor guard off again:
MENU
Call up the menu bar, and...
4,2
turn anchor guard off
6.4 MOB alarm and navigation
The MOB - Man overboard - alarm and display will be activated if
you press the [MOB] key on the CP33 keypad and hold it depressed
for two seconds, or activate an external MOB switch (hold two sec-
onds). The MOB display will provide all relevant data for an effi-
cient rescue operation - refer to details on the rear of the front page.
To turn the MOB function off again:
MENU
Call up the menu bar, and...
4,2
turn the MOB function off
To check the last activated MOB position:
MENU
Call up the menu bar, and...
6,2
select MOB position
Summary of Contents for CP33
