CP33 Pilot menu & navigation examples
Chapter 6-11
A course line will now be drawn from actual position (ship’s posi-
tion) to destination point (cursor’s position).
Next destination: While on the way, you can easily
move the cursor
to the next destination
, and when ready to change navigation leg...
GOTO
Press
[GOTO]
and
[2]
to...
2
“Restart to approaching point”
- a new course line will be drawn from ship’s position to destination.
To turn NAV mode off again:
GOTO
Press
[GOTO]
and
[3]
to...
3
“Turn NAV off” from active chart display
or...
MENU
Press
[MENU]
and
[4], [2]
to...
4,2
“Turn NAV off” via the menu
6.5.2 Waypoint navigation
There are two ways of activating Waypoint navigation:
From the chart display using [GOTO] or from the menu system.
From the chart:
CHART
Shortcut
to
chart
display
Place cursor on destination waypoint
GOTO
Select NAV mode, and...
2
Select
Waypoint
This will activate the pop-up window “Navigate to WP” - now
follow the procedures from the
a few lines further ahead, or press
[ENT] to start navigation.
Summary of Contents for CP33
