922-00027001/2.2
43
Defining the IP address on the Processor Unit network adapter
The communication between the Processor Unit and the Sonar Head is made using a
high-speed Ethernet cable. If a Processor Unit is not configured to connect to the sonar, you
must define which IP Address and Subnet mask the Ethernet adapter in the Processor Unit
shall use for this communication.
Prerequisites
This procedure is made for the Microsoft
®
64-bit Windows 10 operating system. It is
assumed that you are familiar with the Windows
®
operating systems, computer technology,
and interface principles.
Context
As long as you do not change the Processor Unit to another computer, or replace the network
adapter in your Processor Unit, you will only need to do this once.
Procedure
1
On the Processor Unit, close the FM90 software.
2
Open the
Network and Sharing Center
dialog box.
a
In the bottom-left corner of your desktop, type “network and sharing center” into
the Cortana search box, then press
Enter
.
Observe that the Control Panel opens.
b
On the left-hand menu, select
Change adapter settings
.
c
Click once on your network adapter to select it, then right-click and select
Properties
on the short-cut menu.
d
On the list of connections, select
Internet Protocol 4 (TCP/IPv4)
, and then
Properties
.
3
Select
Use the following IP address
, and type the IP address and network mask.
IP Address:
192.168.1.N
(
"N" can be any number from 1 to 254, except 234, which is
the Sonar Head default.
)
Subnet mask:
255.255.255.0
You can leave
Default Gateway
blank.
4
Click
OK
to save the settings, then close all the dialog boxes.
Summary of Contents for FM90
Page 2: ......
Page 140: ... 2018 Kongsberg Maritime ...
