12 |
Installation |
HS80/MX575C User Manual
4.
Place the HS80/MX575C over the marks to ensure the planned hole centers align with the
true hole centers (adjusting as necessary).
5.
Use a center punch to mark the hole centers.
6.
Drill the mounting holes with a 9 mm bit appropriate for the surface.
7.
Place the HS80/MX575C over the mounting holes and insert the mounting screws through
the bottom of the mounting surface into the HS80/MX575C.
Warning:
When installing the HS80/MX575C, hand tighten only.
Damage resulting from over tightening is not covered by the warranty.
Pole mounting the HS80/MX575C
If you need the GPS-assisted roll measurement, install the HS80/MX575C perpendicular to the
vessel’s axis. If you do not need this measurement, install the HS80/MX575C parallel with the
vessel’s axis. For more information refer to Figure 2-2 on page 8 and Figure 2-3 on page
9.
Complete the following steps to pole mount the HS80/MX575C:
1.
Determine the desired location and proper orientation for the HS80/MX575C. See “Mounting
orientation” on page 8“ for information on determining the desired orientation.
2.
Hand tighten the HS80/MX575C on the pole until snug (unit is stable on pole) while ensuring
correct orientation.
Warning:
Hand tighten only. Damage resulting from over tightening
is not covered by the warranty.
3.
Use the set screws on the long sides of the base (see Figure 2-6 on page 10) to secure the
HS80/MX575C in place (3/16” Allen wrench not included).
Summary of Contents for HS80/MX575C
Page 1: ...ENGLISH HS80 MX575C User Manual...
Page 55: ...988 10221 001...
