Simrad SH80
96
851--164300 / C
Display set-up
Observe the following procedure to set up the display and retrieve
simulated sonar echoes.
1
Refer to the instruction manual for the display unit, and
adjust the picture size so the grey picture frame is shown in
the outmost part of the display frame.
2
Use the trackball and the
Select
button on the Operating
Panel, and observe this procedure to obtain a simulated echo
on the screen.
a
Move the cursor to the
Setup
tab on the right-hand side
of the main menu, and press the
Select
button.
- The
Setup
menu will be displayed.
b
Move the cursor to the
Test...
button in the
Setup
menu,
and press
Select
.
- The
System test
menu will now appear in the menu
field.
c
Move the cursor to the
Installation Menu
button and
press
Select
.
- The
Installation menu
will now appear on the top of
the screen.
d
Move the cursor to
Simulation
and press the
Select
button. Select
Modes
and then
Auto
.
3
Check that simulated echoes are displayed on the screen after
a few seconds.
- If not, check that the tilt angle in the upper left-hand
corner is set to 0 degrees.
Summary of Contents for SH80 - REV C
