SET
M
M
2200 PRO
2200 PRO
6.4 Run Time
- Enter the programming mode by pressing the set button
(4) for 3 seconds. The screen (Fig. 15) to the right will appear. Use the up
(1) and down (3) buttons to select the run time symbol (blinking).
Press the set button (4) and the run time will appear (Fig. 16). You can
adjust this value up or down by pressing the up (1) or down (3) buttons.
The run time should be set long enough to drive the motor from one
limit to the other.
Press the set button (4) to save the programmed run time and return to
the programming screen (Fig. 15). To adjust other values see the
following sections or press the stop button (2) to return to normal
operating mode.
6.5 Tilt Time
- Enter the programming mode by pressing the set button
(4) for 3 seconds. The screen (Fig. 17) to the right will appear. Use the up
(1) or down (3) buttons to select the tilt time symbol (blinking).
Press the set button (4) and the tilt time will appear (Fig. 18). You can
adjust this value up or down by pressing the up (1) or down (3) buttons.
Note: unless you are using a window covering that has louvers that tilt
open on the reverse of direction, the tilt time should be kept at 00.0
Press the set button to save the programmed tilt time and return to the
programming screen (Fig. 17). To adjust other values see the previous
sections or press the stop button (2) to return to normal operation
mode.
Note: At any time in the programming process you can return to
normal operating mode by pressing the stop button (2) twice.
Note: unless you are using a window covering that has louvers that tilt
open on the reverse of direction, the tilt time should be kept at 00.0
SET
M
M
M
M
SET
M
M
sec
Fig. 15
Fig. 16
SET
sec
Fig. 17
Fig. 18
8
