2200 PRO
2200 PRO
7.3 Test Mode
- To enter test mode press and hold the stop button (2)
and press the auto/manual button (6) then release both. The test
screen (Fig. 20) will appear and after 2 seconds the unit will go into test
mode (Fig. 21). You can confirm the unit is in test mode by the small ON
displayed in the upper right of the screen. The actual measured weather
conditions will be displayed on the screen. In test mode all functions a
set to very short times to allow the installer to quickly test the unit.
To exit test mode press the stop button. The ON will no longer be
displayed in the upper right of the screen and the 2200 is in normal
operating mode.
7.4 Blocked Mode
- You can only enter blocked mode when the 2200
is in automatic mode. To enter blocked mode press the up (1) and
down (3) buttons simultaneously and the blocked screen (Fig. 22) will
appear. In blocked mode the 2200 will give a constant up to the motor
locking the window covering in the up position.
To exit blocked mode press the stop button.
7.5 Reset
- To reset the 2200 to the last programmed values press
the reset button (5). Note, on the surface mount 2200 the face
plate will have to be removed as shown (Fig. 23)
7.6 Total Reset
- To return the 2200 to factory settings press the set
button (4) for 3 seconds. The 2200 will go into programming mode
with the set icon displayed on the lower left of the screen. Press the reset
button (5). Note, on the surface mount 2200 the face plate will have to
be removed as shown (Fig. 23)
ON
Klx
mph
Fig. 20
Fig. 21
Fig. 22
Fig. 23
10
