Simunition 8971021SP, User Instruction Manual

Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by 

®

. 

www.simunition.com 

   Page 12 of 36 

© 2019 GD-OTS Canada  

8971965.FTSIM_rev12 

Procedure #1 

Cleaning the FX

®

 9003 Protective Mask

, Single lens 

with Open Cell Foam (8971970SP) (Discontinued) 

The 

FX

®

 9003 Protective Mask 

with

 Single Lens configuration (see Fig. 19 and 20) cleaning procedures shall be carried 

out as follows: 

1.

  Using a clean container, wash the inner and outer surface of the Single lens 

FX

®

 9003 Protective Mask 

by immerging 

in a solution of two (2) teaspoons of detergent (mild dish-hand washing liquid with antibacterial) for every 4 liters of hot 
water, at a temperature of (35°C/ 95°F).  Remove the 

FX

®

 9003 Protective Mask 

from the soapy solution and drain the 

outside and inside of the 

FX

®

 9003 Protective Mask

. 

2.

  Then, rinse the 

FX

®

 9003 Protective Mask 

thoroughly with cold clean water and drain water from the inside and outside 

of mask. 

Drying the FX

®

 9003 Protective Mask 

1.

  Using a clean cloth, wipe the inside of the 

FX

®

 9003 Protective Mask

. Make sure there is no excess moisture. 

2.

  Wipe the lens carefully with a soft (non-abrasive) dry cloth, making sure the water stains from the inside and outside 

surfaces of lens are removed. 

3.

  Then, allow the 

FX

®

 9003 Protective Mask 

to dry completely before storing it in its storage pouch (8971315SP). 

Procedure #2 

Cleaning the FX

®

 9003 Protective Mask, Double lens with Open Cell Foam (8972220SP) (Discontinued) 

The 

FX

®

 9003 Protective Mask 

with

 Double lens configuration (see Fig. 22 and 23) cleaning procedures shall be carried 

out as follows: 

Note: do not immerge the mask in water

1.

  By using a clean soft wet cloth, wash the inside and outside surfaces (

do not immerge the mask in water

) of the 

FX

®

9003 Protective Mask 

with a solution of two (2) teaspoons of detergent (mild dish-hand washing liquid with antibacterial) 

for every 4 liters of hot water, at a temperature of (35°C/ 95°F).  

2.

  Then, with the use of fresh cold water, a soft wet cloth and without immerging the mask in the water, wipe the inside and 

outside of 

FX

®

 9003 Protective Mask

.  

Drying the FX

®

 9003 Protective Mask 

1.

  Using a clean cloth, wipe the inside of the 

FX

®

 9003 Protective Mask

. Make sure there is no excess moisture. 

2.

  Wipe the lens carefully with a soft (non-abrasive) dry cloth, making sure the water stains from the inside and outside 

surfaces of lens are removed. 

3.

  Then, allow the 

FX

®

 9003 Protective Mask 

to dry completely before storing it in its storage pouch (8971315SP).