Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
®
.
www.simunition.com
Page 14 of 36
© 2019 GD-OTS Canada
8971965.FTSIM_rev12
Re-install the Close Cell Foam with the FX
®
9003 Goggle Frame with Single lens
installed
Forehead Foam Installation
Prior to re-
installing the Forehead Close Cell foam onto
the Frame Goggle, identify the thinner edge of the
Forehead foam (see Fig. 28). Then, bend the Forehead
foam with your fingers and join both ends together (see
Fig. 28a).
Then align the thinner edge of the Forehead Foam right
in the center of the Goggle frame (see Fig. 29). Make
sure that the thinner edge of the Forehead foam is also
aligned with the edge of the Forehead Velcro
®
Hook
(see Fig. 29).
Then, firmly press the Forehead Foam against the
Forehead Velcro
®
Hook with your fingers. For maximum
comfort, make sure to maintain the thinner edge of the
Forehead Foam in place to properly align it with the
Forehead Velcro
®
Hook edge (see Fig. 31).
Fig. 28
Fig. 28a
Fig. 29
Center of the Goggle frame
Thinner
edge
