E Q U O B O X R T U - M o d B u s
–
U s e r G u i d e R e v . 2 . 2
S I N A P S I S . r . l . |
V i a d e l l e Q u e r c e 1 1 / 1 3 - 0 6 0 8 3 B A S T I A U M B R A ( P G )
–
I t a l y
T . + 3 9
0 7 5 8 0 1 1 6 0 4
- F . + 3 9
0 7 5 8 0 1 4 6 0 2 |
w w w . s i n a p s i t e c h . i t
i n f o @ s i n a p s i t e c h . i t
39
•
Output 2: when an event occurs, you can enable an operation according to the device connected to
Output 2, such as:
o
Open: commands to open
o
Close: commands to close
o
Pulse: generates a pulse
•
Add to Log: stores the alarm in the meter’s log
•
Send Email: sends an email notification in the event of an alarm (Ref. Chapter 5.3, 8.3)
•
Save: Press Save to save the configuration
16.6
Condition set according to the Consumption threshold
Select the Consumption threshold item.
Figure 46 - Completing the creation of an event
The cells to be filled out are:
•
Event Name: enter the name of the event being created
•
Data Type: select the type of meter data. The data you can select are those that have already been set
for every single meter. For more information, refer to Chapter 15
•
Consumption threshold: insert a consumption threshold beyond which trigger the alert. The
consumption threshold is a value differential as described in Chapter 14.2
•
Interval: select a time interval within which the produced energy value is calculated to compare with
the threshold consumption value set. The interval selection may be greater than or equal to the
sampling value set in the energy meter configuration, see Chapter 15
•
Event closure notification: sends an email notification whenever an event is closed
•
Output 1: when an event occurs, you can enable an operation according to the device connected to
Output 1, such as:
o
Open: commands to open
o
Close: commands to close
o
Pulse: generates a pulse
•
Output 2: when an event occurs, you can enable an operation according to the device connected to
Output 2, such as:
o
Open: commands to open
o
Close: commands to close
o
Pulse: generates a pulse
•
Add to Log: stores the alarm in the meter’s log
•
Send Email: sends an email notification in the event of an alarm (Ref. Chapter 5.3, 8.3)
•
Save: Press Save to save the configuration
