E Q U O B O X R T U - M o d B u s
–
U s e r G u i d e R e v . 2 . 2
S I N A P S I S . r . l . |
V i a d e l l e Q u e r c e 1 1 / 1 3 - 0 6 0 8 3 B A S T I A U M B R A ( P G )
–
I t a l y
T . + 3 9
0 7 5 8 0 1 1 6 0 4
- F . + 3 9
0 7 5 8 0 1 4 6 0 2 |
w w w . s i n a p s i t e c h . i t
i n f o @ s i n a p s i t e c h . i t
32
b.
Non-integrated Model: inserting a not integrated energy meter into the system in the right side of the
window will not displayed the image of the energy meter in insertion. See Figure 32. This option will
be described in detail in Section 3.
Always check the voice memory usage to check the available
space before inserting a new energy meter. You can enter up to a maximum of 60 energy meters
Figure 32
–
Not integrated Energy Meter
15.3
Section 3
In Section 3, it is possible to select/change the ModBus input registers of integrated devices or not. It
’s possible
to interact directly with five sets of values such as:
•
Power
•
Energy
•
Volt
•
Current
•
Other
The quantity displayed that can be stored depends on the protocol of the energy meter during the insertion.
For each group you will be able to interact with the individual records using the Advanced Settings item. Figure
33 is an example of the log management
Figure 33 - Edit reading parameters
The management of the data follows the process below
The editable fields for a integrated energy meter are:
Request
register
Data format
[Data Format]
Readout data
[Readout Status]
TA TV Multiplier
[Multplier]
Add offset
[Offset]
