Flash connection
The X-sync cable for controlling the flash generator has to be attached to the X-contact of your ca-
mera.
Handling
Because this adaptation can only be used in the slave mode, exposures cannot be triggered by means
of the shutter release button on the camera. Exposures can be triggered in the following manner:
a) via the computer, either by using the user interface or by using the keyboard.
b) by means of Manual Cable Release 493.03.060 attached to the respective connector.
By pressing the shutter release that is located on the Adapter Plate for Sinar p3. This shutter release
has two pressure points: The first pressure point activates the exposure metering on the camera. The
second pressure point triggers the exposure.
Storage
When the Sinarback is not mounted on the camera, we strongly recommend that the CCD Protective
Cover is always be attached to the Sinarback to protect it and the CCD sensor from dirt and physical
damage.
Sinar Photography AG - Farbhofstrasse 21 - 8048 Zürich/Switzerland
Phone +41 (0)44 217 80 30 - Fax +41 (0)44 217 80 50 - contact@sinar.ch - www.sinar.ch
13.10.10 - Seite 7
