Sinbo SHC 4357, Instruction Manual

- 3 -

• Always keep the blades clean and lubricated.
• After each use of the hair clipper clean the attachments and the blade block with the
brush supplied to remove the cut-off hair.
• Never leave the operating unit unattended.
• Switch the hair clipper off during breaks between operation cycles or when you are not
using it.
• Do not allow children to touch the power adapter body during the unit charging.
• Do not allow children to use the units as a toy.
• This unit is not intended for usage by children.
• During the unit operation and breaks between operations cycles, place the unit out of
reach of children and disabled persons.
• The unit is not intended for usage by physically or mentally disabled persons (including
children) or by persons lacking experience or knowledge if they are not under supervision
of a person who is responsible for their safety or if they are not instructed by this person
on the usage of the unit.
• For children safety reasons do not leave polyethylene bags used as a packaging
unattended.
Attention! Do not allow children to play with polyethylene bags or packaging film.

Danger of suffocation!
• Do not attempt to repair the unit. Do not disassemble the unit by yourself, if any
alfunction is detected or after it was dropped, unplug the unit and apply to any authorized
service center from the contact address list given in the warranty certificate.
• To avoid damages, transport the unit in the original package only.
• Keep the unit in a dry cool place out of reach of children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY, ITS COMMERCIAL USAGE AND
USAGE IN PRODUCTION AREAS AND WORK SPACES IS PROHIBITED.

BEFORE THE FIRST USE
After unit transportation or storage at low temperature keep it for at least three hours
at room temperature before switching on.
– Unpack the unit completely and remove any advertisement stickers that can prevent
the unit operation.
– Check the unit for damages; do not use it in case of damages.
– Before connecting the power adapter, make sure that voltage of the mains corresponds
to unit operating voltage.
– Charge the battery and lubricate them blade block following the recommendations
below.
The hair clipper can operate only on the built-in rechargeable battery.

Battery charging
Full charging of the accumulator battery is enough approximately for 35 minutes of
continuous operation.